BREAKAWAY TRAILER BRAKE WIRING INSTALL

This will usually mean that 2 axles will need to be braked. The vehicle/trailer combination must be capable of stopping within 7 m from 30 km/h. Trailers over 2000kg must be fitted with Credo direct (cab-controlled) service brakes, a breakaway brake system and an independent parking brake on at least one axle (capable of holding the vehicle at rest on a slope of 1 in 5). Source: 17 pictures about circuit diagram: Wiring trailer diagram brakes electric brake dexter wire lights schematic rh combined signals turn common north market american very source. The vehicle/trailer combination must be capable of stopping within 7 m from 30 km/h. To wire a tandem axle trailer with electric brakes, the first step is to determine the gauge of the brake wire. The tow coupling must have a rating at least commensurate with the laden trailer and have either Indirect (override) or direct (cab-controlled) type brakes can be fitted ( Credo Wireless Brake Controller). Trailers must be fitted with a service brake on at least one axle. After the switch has been installed and wired in, pull the lanyard pin out of switch to make sure the brakes engage.

BREAKAWAY TRAILER BRAKE WIRING INSTALL

Wire the breakaway switch as in wiring diagram. Trailer Breakaway Switch - Install and Test Love Your RV 91. pull on the switch and will allow the switch to swivel. The towing capacity of the vehicle being used to pull a trailer should be considered when decisions whether to fit brakes to a trailer are being made. The breakaway should be bolted to the trailer frame with minimum 1/4 bolt that will accept a 75 lb. BLACK 12 volt tow vehicle auxiliary line RED Stop light circuit. The unit should be located so that the electrical wiring and brake lines can be neatly routed directly to the towing vehicle and trailer brakes. The shorter the wiring between the unit and the electrical power source, the smaller the voltage drop. The vehicle/trailer combination must be capable of stopping within 7 m from 30 km/h. When selecting the location, the following items should be considered: 1. The brakes will release when the pin is replaced in the switch. Trailers over 2000kg must be fitted with Credo direct (cab-controlled) service brakes, a breakaway brake system and an independent parking brake on at least one axle (capable of holding the vehicle at rest on a slope of 1 in 5). The electric brakes and brake lights of the trailer should immediately activate and the battery level light should illuminate. There is no legal requirement for trailer brakes on trailers with a Gross Trailer Mass (GTM) NOT exceeding 750kg. Pull the Breakaway pin from the breakaway switch attached to the A frame.

Breakaway trailer brake wiring